Our Stage I kit is shipping at 100+ Wheel Horsepower at 6
pounds of boost. The supercharger kit is capable of 14+ pounds of boost, but
motor and drive train upgrades are required. The Prowler 1000 boasts a consumer friendly bolt-on solution
that more
than doubles your power. We recommend using Premium Gas, 92+ Octane. The
Stock Prowler has about 65 Rear Wheel Horsepower. For those
desiring more power, numbers in excess of 140 RWHP our Stage II motor package
is coming. Kit Includes MPI's GEMS (Global Engine Management System) Fuel
Controller. This kit is fully compatible with the DynaTek Ignition system.
Highlights:
This
kit was designed by a team of experienced engineers with 4 specific goals in
mind:
Easy
Install - Minimum cutting and no fabricating. Consumer installs
pre-assembled sub systems. Typical 4-6 hrs install plus clutch changes and any
desired instrumentation.
Dependable
HP - Build on the reliability of the Arctic Cat. Plus compensating for
the inherent weaknesses.
Instantaneous
Throttle Response - MPI knows this is required for an A+ fun factor.
Repeatable
Performance - The system must not require "tinkering" to make it
run.
We
have met and exceeded our design goals in all aspects. Each of the key factors
mentioned have met the requirements of the most discriminating enthusiasts.
Major Components:
- C15-60 Rotrex Supercharger
- Reliable no-slip cog belt
drive system
- Billet Bracketry throughout
- High volume high efficiency
bar and plate intercooler (with fan)
- High Volume, High Pressure
Fuel Pump
- Plug and Play Electronic Fuel
Controller included
