RHINO 660 Supercharger Kits

Rhino 700 - In Development; Coming Soon!

Rhino Stage I Performance:

Our Stage I kit is shipping at 52 Wheel Horsepower (about 80 at the motor) at 10 pounds of boost. The Rhino boasts a consumer friendly bolt-on solution to more than double your power. We recommend using Premium Gas, 92+ Octane. The Stock Rhino has about 22 Rear Wheel Horsepower (about 37HP at the motor). For those desiring more power, numbers in excess of 100 Crank HP is coming on Stage II (then Stage III).

Highlights:

This kit was designed by a team of experienced engineers with 4 specific goals in mind:

1. Easy Install - No cutting or fabricating required. Consumer installs pre-assembled sub systems. Typical 4hr install plus clutch changes. 

2. Dependable HP - Build on the awesome reliability of the Yamaha Genesis based 5 valve motor.

3. Instantaneous Throttle Response - MPI knows this is required for an A+ fun factor.

4. Repeatable Performance - The system must not require "tinkering" to make it run.

We have met and exceeded our design goals in all aspects. Each of the key factors mentioned have met the requirements of the most discriminating enthusiasts. 

Recommendations:

 - Gauges are not required, but recommended for Extreme Application. We recommend the ProLogger

 - All Units should probably have the High Pressure Radiator Cap.

 - As Hard Riding increased you should add the Electric Water Pump - This protects from OEM Pump Cavitation

 - For All out Hard Riding, Use The 3 Pass Radiator, Electric Pump Kit & the cap.

Stage I Specifications: - CLICK HERE

Pictures: - CLICK HERE

Frequently Asked Questions: - CLICK HERE

Technical Service Bulletins:

• Call for more details or to get yours shipped today!