TERYX FI Supercharger Kit

Teryx 750 FI Stage I Performance:

Our Stage I kit is shipping at 80+ Wheel Horsepower at 6 pounds of boost. The supercharger kit is capable of 15+ pounds of boost, but motor and drive train upgrades may be required. We have run our test units as high as 12 psi on racing fuel with larger injectors successfully, but we make no claims of OE part endurance at the boost levels above 6-8psi. The Teryi FI boasts a consumer friendly bolt-on solution that more than doubles your power. We recommend using Premium Gas, 92+ Octane. The Stock Teryx has about 42 Rear Wheel Horsepower. For those desiring more power, numbers in excess of 100 RWHP our Stage II motor package is coming. Kit Includes MPI's GEMS (Global Engine Management System) Fuel Controller. This kit is fully compatible with the DynaTek Ignition system.

Highlights:

This kit was designed by a team of experienced engineers with 4 specific goals in mind:

Easy Install - Minimum cutting and no fabricating. Consumer installs pre-assembled sub systems. Typical 4-6hr install plus clutch changes and any desired instrumentation.
Dependable HP - Build on the reliability of the Polaris motor. Plus compensating for the inherent weaknesses.
Instantaneous Throttle Response - MPI knows this is required for an A+ fun factor.
Repeatable Performance - The system must not require "tinkering" to make it run.

We have met and exceeded our design goals in all aspects. Each of the key factors mentioned have met the requirements of the most discriminating enthusiasts.

Major Components:

- C15-60 Rotrex Supercharger

- Billet In-Tank Fuel Pump Assembly including new high volume pump.

- Reliable no-slip cog belt drive system

- Billet Bracketry throughout

- High volume high efficiency bar and plate intercooler with fan

- Plug and Play Electronic Fuel Controller included

Recommendations & Notes:

- Gauges are not required, but recommended for Extreme Application. We recommend the ProLogger

- Our Primary Overdrive Clutch Cover

- Since the Teryx has a 50MPH speed limiter, we recommend a speedometer fooler / recalibrator.

- Heavier Primary Weights may be required.

- Larger injectors will be required for higher boost levels. A kit is available from MPI.

Stage I Specifications: - CLICK HERE

Pictures: - CLICK HERE

Frequently Asked Questions: - CLICK HERE

SUPERCHARGER KITS		US Dollars
mst-1000	Teryx 750 FI Stage I 6PSI Supercharger Kit - Complete (less gauges)	$ 4295

prc-8005	Overdrive Primary Clutch Cover	$ 125.00
hse-0099	SpeedoHealer for Teryx (click for detail)	$ 109.95
hse-0055	DynaTek Programmable Ignition and Fuel Trim Control - Customized (user can purchase programming module for custom work)	$ 249.95
hse-0053	DynaTek Programming Module & User Control. Allows selection of 4 ign curves & fuel trimming	$ 249.95
ggt-1701	ProLogger Multifunction (WideBand, Boost, 2 Temps, RPM & Datalog) -- see www.Prologger.com for more details ($50 off with SC kit)	$ 699.00
ggt-2200	Analog Autometer Boost Gauge	$ 66.29
ggt-xxxx	Digital Air Fuel Gauge -- DISCONTINUED due to reliability issues	------
ggw-0100	Econo Blower Oil Temp or Engine Water Temp Digital Gauge & Clock	$ 119.95
ggw-0200	Dual Oil Temp AND Engine Water Temp Gauge	$ 252.95
ggw-0250	Water Temp Sending Unit Adaptor & Clamps	$ 39.95

DYNO
INFORMATION

Call for more details or to get yours shipped today!